Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateGhost Controls Gate Repair in Crestline, CA | Manor Gate Repair
If your Ghost Controls opener quit after the last hard freeze, or the gate drags where a pine root lifted the post, we can get it working again. Manor Gate Repair provides independent Ghost Controls service across Crestline, and we’re the crew that other mountain homeowners call when factory support can’t explain what the altitude and snowmelt are doing to their equipment. Call (844) 703-6053 for a straight answer and a real fix, not a scripted phone tree.
We’re not a Ghost Controls dealer. We’re a multi-brand gate specialist that works on the brand you already have, including all four Ghost Controls product lines that show up on Crestline driveways. If you need Ghost Controls in San Bernardino County, we cover that too. From diagnosis to installation, your gate gets restored to spec. Call (844) 703-6053 and tell us what it’s doing, or not doing.
Why Crestline Residents Choose Us for Ghost Controls Service
Most gate companies around here either sell one brand or fix fences. Manor Gate Repair works on nine gate automation brands, including Ghost Controls, LiftMaster, FAAC, BFT, Linear, Viking, DoorKing, Elite, and Mighty Mule. So when a Ghost Controls board fails, we don’t try to convince you that a whole new system from a different manufacturer is the only answer. The right fix, not the easy upsell.
Nelson Pryce, our owner and lead technician, knows Crestline’s particular challenges because he’s been working mountain gates for years. Steep lots, pine-root heave, snowmelt that pools inside control housings. We’ve seen almost every way a Ghost Controls opener can fail up here, and we have the parts and the patience to make it right.
Styles & brands we work with





Common Ghost Controls Gate Repair Problems We Solve in Crestline
- Control board corrosion from snowmelt ingress. Ghost Controls boards aren’t sealed for months of wet freeze-thaw. When snow piles against the housing and melts into it, the board gets intermittent, then dead. We replace with OEM and seal the housing properly for mountain weather.
- Battery backup failure after hard freezes. Ghost Controls batteries lose capacity when charged below freezing. After a Crestline winter, a backup battery that tests fine at 60 degrees may be useless at 28. We test under load and replace with quality aftermarket batteries that handle cold better than the stock units.
- Arm and hinge binding from frost-heaved posts. When a footing shifts, the gate goes out of plumb and the Ghost Controls arm strains. These openers don’t have the torque headroom to push a racked gate, so the motor stalls or strips the gear. We realign the gate before the opener destroys itself.
- Solar panel underperformance from pine sap and shade. Forested lots in Crestline mean panels get coated in sap and spend half the day in shadow. The battery drains, and the opener throws low-voltage faults. We remount panels where they actually catch sun, usually the cabin’s south wall.
- Gate dragging after rain or snowmelt. Pine roots lift posts, freeze-thaw shifts footings, and suddenly the gate drags and the opener struggles. This is one of the most common Ghost Controls service calls we get in Crestline, and it’s almost always fixable with realignment, not replacement.
Ghost Controls Service in Crestline: What Local Conditions Mean for Your Equipment
Crestline’s hard freezes and snow load routinely crack Ghost Controls solar panels mounted on gate posts. Pine needles clog the charge controller vents. We routinely remount panels to south-facing cabin walls rather than leaving them on the gate, because a panel frozen to a post at 4,600 feet is a panel that’s going to fail sooner than it should. That’s not a factory recommendation. It’s what works here.
On a call in the Valley of the Moon area, we found a Ghost Controls dual swing opener that had stopped after a February freeze. For Lake Arrowhead Ghost Controls service, we handle similar mountain conditions. The control board was corroded from snowmelt that pooled inside the housing, and one arm was binding because a pine root had lifted the post. We replaced the board with an OEM unit, realigned the gate, and remounted the solar panel to the cabin’s south wall. The gate has run through two winters since without a call-back.
A gate that hesitates is a gate that’s telling you something. The job is to listen before you wrench.
Ghost Controls Models & Products We Service in Crestline
We service the full Ghost Controls lineup: the Ghost Series automatic gate openers, HD single swing opener kits, dual swing gate opener systems, and solar-compatible packages. For parts, we use Ghost Controls OEM control boards, arms, and batteries for reliability, but we substitute quality aftermarket batteries and hardware where OEM parts fail prematurely in mountain conditions. That’s a judgment call we make based on what actually holds up at altitude.
One honest piece of guidance: if a Ghost Controls opener is over 8 to 10 years old and the board is corroded, we’ll recommend replacing the unit rather than chasing repeated repairs. Throwing money at a board that’s going to fail again in the next freeze doesn’t serve anyone.
See the difference
Before
After
Before
After
Before
AfterGhost Controls Service Pricing in Crestline
Ghost Controls repair in Muscoy follows similar pricing, and in Crestline it typically runs $180 to $340 for board replacement or motor repair, and $250 to $450 for a full arm and hinge rebuild with gate realignment. Battery backup replacement runs $95 to $180. The cost depends on what actually failed and whether the gate itself needs realignment work, which is common here because of freeze-thaw heave.
Every job gets a quoted price before we start. No surprises on the invoice. We offer free estimates, and a service call includes a straight diagnosis. If the fix is straightforward and the parts are on the truck, we handle it same-day. Call (844) 703-6053 for an exact quote, estimates are free.
Serving Crestline, CA — Our Local Coverage Area
We’re based in the Crestline area and know this community well. Use the map below to see our service coverage — if you’re nearby, we can almost certainly help.
FAQs – Ghost Controls Gate Repair in Crestline
Snowmelt usually gets inside the control board housing and corrodes the board, or the battery gives out from being charged at freezing temperatures. Snow piled against the housing is the main culprit. We seal the housing properly and test the board and battery under load to see which one actually failed.
Not for long. Ghost Controls openers don’t have the torque headroom to push a gate that’s out of plumb, so the motor stalls or the gears strip if you keep using it. The fix is realigning the gate first, then checking the opener for damage. Call (844) 703-6053 before the opener eats itself.
Usually it’s the panel getting shaded or coated with pine sap, not the panel itself failing. We test both the panel output and the battery under load. In Crestline, we remount panels to south-facing cabin walls because pine shade and snow load on gate posts cause most of the charging problems we see.
We carry OEM control boards, arms, and batteries for Ghost Controls systems, including older models. Where OEM parts fail prematurely in mountain conditions, we substitute quality aftermarket batteries and hardware that hold up better. You get the right part for the job, not whatever’s on the truck.
Yes. Many older Crestline properties still have manual gates that need to be retrofitted for Cal Fire’s 100-foot defensible-space clearance around the home. We automate those gates with a Ghost Controls opener and make sure the swing path clears the required space. Call (844) 703-6053 for a site assessment.
Service Areas Near Crestline
We serve all of Crestline, including the Valley of the Moon and Lake Gregory areas, and the surrounding mountain communities. If you’re in the San Bernardino Mountains or down the hill in the valley, we can help. For more information on our coverage, see our Crestline service area page, or check our Ghost Controls service in Montclair and Ghost Controls service in Redlands pages for valley coverage.
Book Your Ghost Controls Service in Crestline Today
If your Ghost Controls opener is dead, dragging, or throwing faults after the last storm, call (844) 703-6053. We’ll diagnose the actual problem and give you a straight quote before any work starts. Same-day service is available for most repairs in Crestline. Free estimates.
Written by Nelson Pryce, Owner at Manor Gate Repair, serving Crestline and the surrounding mountain communities.